Such an idea is very intuitive. But I find that it is impossible in the Part WB. When I did my research on why then I stumbled upon the following phrasing inside of the Part Loft documentation:
This sounds to me as if hollow lofts are not really feasible using the older Part WB. But as you can see in the above video the same thing is entirely possible in the PartDesign WB. Thus I conclude that this limitation of the Part WB is an inconsistency that could confuse new users. Doesn't this inconsistency degrade the effectiveness of Part WB workflows?The sketch must contain only one open or closed wire or line (can be multiple lines, if those lines are all connected as they are then a single wire)
Part WB Loft: https://green-candy.osdn.jp/external/fo ... ng_1.FCStd
PartDesign WB Loft: https://green-candy.osdn.jp/external/fo ... n_ok.FCStd
Wouldn't it be a good idea if somebody took a look at that Part Loft programming and made it support hollow lofts aswell?