Jee-Bee wrote: ↑Wed Aug 10, 2022 8:06 pm
Even if TD can use model dimensions, sketcher will never be a replacement for TD!
You're right, and I never said that BTW
By the way using model dimensions is impossible in more cases than where it is helpfull. Model dimensions is a nice selling point and not more than that...
I've achieved tons of drawings this way during many years in a previous job, by importing up to 80% of dimensions directly from 3D model (well dimensioned), even on complex drawings. This is not only a selling point, this is a powerful point, and quite unknown on this forum it seems to me. Even with Solidworks it requires some practice and knowhow of course, but that's so powerful at the end.
I try to explain this workflow here since a while, but the answer of FC users is always the same, they don't understand or they don't believe me (BTW some SW users don't understand this workflow neither ...). Well it's up to you guys
Anyway, this point is a bit offtopic, want not hijack this thread. Let's focus on diameter on flat lines maybe.