Community opinion polling central thread

[openBrain]

Hi all,

I often see cases where, in the case of bug fixing or feature enhancement, developer has to make a choice about FreeCAD behavior (because of limitations, interferences, ...).
Sometime choice is obvious, but sometime it may be balanced and community opinion is more than welcome.
Problem is that it happens in the middle of the thread after the original discussion took place. Then feedback from users is very limited, because no one can follow every topic, just in case opinion would be requested.

This thread proposes to improve this by centralizing links to community "polls" inside the various threads of the forum.

To stay efficient, posts in this thread should be limited to a single sentence describing the polling purpose (workbench/feature/condition) and a link to the post (not the thread) where it lies.
Before linking into this thread, you should ensure that linked post is self-explaining so you will get valuable opinion without the need for forumer to read the entire thread.

Be warn, I'll be quite strict that this thread shouldn't be cluttered or hijacked. If you have feedback regarding this topic, please send me a PM.

[openBrain]

Opinion about capabilities of Sketcher tangent constraint in continuous mode :
https://forum.freecadweb.org/viewtopic. ... 30#p569030

[TheMarkster]

Poll about a PR to allow to skip some dialogs in Part workbench.

https://forum.freecadweb.org/viewtopic.php?f=8&t=65291

[ChemicalCoal]

Poll: Expanding allowable hole profiles.
https://forum.freecadweb.org/viewtopic.php?f=8&t=70944