Greetings to the Community!
Here https://forum.freecad.org/viewtopic.php ... 85a94705c2 an excellent modeling exercise (Part Design, Draft and part) and 3D dimensioning, especially since in "Draft" there is no tangent "snap", the attached file contains the graphic constructions, performed with "Draft", to determine tangent arcs to two circumferences.
An excellent exercise proposal
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
Be nice to others! Respect the FreeCAD code of conduct!
An excellent exercise proposal
- Attachments
-
- Exercise_10_domad.png (216.52 KiB) Viewed 671 times
Re: An excellent exercise proposal
Is there a good reason to not use Sketcher?
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.
Re: An excellent exercise proposal
Hi @chrisb, hello to the Community!
No, no reason, but since almost all of them use "Part design+Sketcher" I think it's good to show other "training offers".
No, no reason, but since almost all of them use "Part design+Sketcher" I think it's good to show other "training offers".