wandererfan wrote: ↑Fri Jun 24, 2022 3:18 pm
maker wrote: ↑Sun Jun 19, 2022 11:47 am
Why is it not possible to create a hatching of this detail view?
There are a number of superimposed edges in the projection of the detail. This happens sometimes
and confuses the face finding algorithm.
A very small bit of comfort is that this file is an excellent test case for the replacement face finder which is in development.
@wandererfan
thank you for the info about your analysis.
Of course, I couldn't stop thinking about the fact that
no hatching could be created in the
detail view.
For this reason I deleted the created TD page again and started a new one.
Again I set the selected drawing scale to 2:1 and kept it throughout.
Interesting was what I then noticed:
I could suddenly create the hatching in the detail view, because the area was selectable.
This surprised me at first and I tried various things.
Only when I increased the ISO Count (default: 0) to 1 for the dimensioning, the hatching disappeared. The effect occurred vice versa. . And it worked also up to scale 5:1 in detail view. But if I scale to 10:1 the hatching disappears in detail view.
So now I come to the conclusion that the problem comes from the change of ISO Count. Poor is for dimensioning reasons that you cannot change ISO Count.
Please check this also.