TechDraw drawing rendering as only gray window

Discussions about the development of the TechDraw workbench
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
User avatar
wandererfan
Veteran
Posts: 6270
Joined: Tue Nov 06, 2012 5:42 pm
Contact:

Re: TechDraw drawing rendering as only gray window

Post by wandererfan »

mcdanlj wrote: Sun Dec 01, 2019 7:11 pm [*]The Vertical-A section is upside down
It looks right side up to me, but I always get turned around with sections.

Here are the 3D and 2D starting points with the section plane shown in both
QCTP_Plane.png
QCTP_Plane.png (60.79 KiB) Viewed 555 times
The is the original shape after the section cut
QCTP_Cut.png
QCTP_Cut.png (55.75 KiB) Viewed 555 times

And here are the results rotated so we are looking down at the cut surface
QCTP_Section.png
QCTP_Section.png (69.76 KiB) Viewed 555 times
If it isn't right, please show what it should look like. Thanks.
mcdanlj
Posts: 69
Joined: Sun Dec 01, 2019 12:10 am

Re: TechDraw drawing rendering as only gray window

Post by mcdanlj »

It was "upside-down" only relative to the prior implementation. And it was made clear earlier in the thread that you had fixed it being previously upside down. So I think it's all good now. ☺ Thanks for your work on FreeCAD!
Post Reply