move center of detailed view

Discussions about the development of the TechDraw workbench
Jee-Bee
Veteran
Posts: 2377
Joined: Tue Jun 16, 2015 10:32 am
Location: Netherlands

Re: move center of detailed view

Post by Jee-Bee »

I was thinking. about the center move tha i never had such a problems in Creo. But than i realize it is a different workflow.
in Creo the following steps are needed
  • Create anchor point witch relate detail view to parent view (i guess)
  • draw spline and from this spline the outer form is created(square/ circle etc)
This anchor is relates the position of the spline to the position on drawing. but is not necessary the center. The center is based on the part that is surrounded by the spline.
Wouldn't this not an more easy workflow?
User avatar
wandererfan
Veteran
Posts: 4651
Joined: Tue Nov 06, 2012 5:42 pm

Re: move center of detailed view

Post by wandererfan »

Jee-Bee wrote: Fri Mar 01, 2019 6:38 pm This anchor is relates the position of the spline to the position on drawing. but is not necessary the center. The center is based on the part that is surrounded by the spline.
Marking out the spline will have to wait for "drawing on top of drawing" is implemented (targeted for v0.19).
Post Reply