Hi,
Need help on cuting holes in spiral line for one circle...
I created two cubes and then in Draft select Polar array with 180 angle and Interval Axis X -0,2 to get it but it is not ok..
I test it with real spiral line and see that holes doesnt go like it shoud...see image
How to create this holes on real spiral?
Thank you
holes in spiral line
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
holes in spiral line
- Attachments
-
- spiral holes.jpg (87.93 KiB) Viewed 562 times
- Shalmeneser
- Veteran
- Posts: 9474
- Joined: Wed Dec 23, 2020 12:04 am
- Location: Fr
Re: holes in spiral line
ok i try, but dont know how to rotate cubes to face the line?
sorry I am not expert, just using freecad time to time
thank you
sorry I am not expert, just using freecad time to time
thank you
- Attachments
-
- rotate cubes.jpg (90.26 KiB) Viewed 535 times
Re: holes in spiral line
Look at the documentation linked above and the Alignment section.
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.
Re: holes in spiral line
it seems that the supported plane for referencing cubes is not perpendicular to spiral axis, it creates a obal efect on cubes pattern
Re: holes in spiral line
yes, i find quick solution to change Y axis of cube...
- Attachments
-
- fix cube in spiral.jpg (112.69 KiB) Viewed 416 times
- Shalmeneser
- Veteran
- Posts: 9474
- Joined: Wed Dec 23, 2020 12:04 am
- Location: Fr
Re: holes in spiral line
You should provide your file each time.