(WORKAROUND) Question about extrude

thomas-neemann · Post by **thomas-neemann** » Thu Jun 30, 2022 3:29 pm

uwestoehr wrote: ↑Thu Jun 30, 2022 2:22 pm ...

thank you for your feedback, will implement some of it. this is also very helpful for the vhs courses that i will be offered from autumn.

thomas-neemann · Post by **thomas-neemann** » Fri Jul 01, 2022 11:28 am

uwestoehr wrote: ↑Thu Jun 30, 2022 2:22 pm ...please encourage users to end up with technical drawings ...

i had speed problems with techdraw until now. I tested it again today with the current version. try this file

and this function

I stopped after more than an hour.

but with this draft function

then part compound and this function previously applied,
I had this result within a minute.

I think that techdraw is useful with this workflow

adrianinsaval · Post by **adrianinsaval** » Fri Jul 01, 2022 5:19 pm

thomas-neemann wrote: ↑Fri Jul 01, 2022 11:28 am try this file

How, you didn't post it

thomas-neemann · Post by **thomas-neemann** » Fri Jul 01, 2022 5:22 pm

adrianinsaval wrote: ↑Fri Jul 01, 2022 5:19 pm ..
How, you didn't post it

Post by **uwestoehr** » Fri Jul 01, 2022 5:33 pm

thomas-neemann wrote: ↑Fri Jul 01, 2022 11:28 am I stopped after more than an hour.

Can you please open a new thread in the TechDraw forum, attach your file there and CC wandererfan and me?

thomas-neemann · Post by **thomas-neemann** » Fri Jul 01, 2022 5:42 pm

uwestoehr wrote: ↑Fri Jul 01, 2022 5:33 pm ...

FreeCAD Forum