Hello everyone,
Here is a Lenz2 wind turbine that I modelled only with Sketcher, Part Design and A2plus. With FreeCAD 0.19 on Debian 11. At first, I started from a DIY tutorial to make a first version by reverse engineering, then I upgrade my wind turbine to obtain this result.
It's not meant to be manufactured, it was just for fun and learning, but I published the 3D model on GrabCAD and someone used it in a 1/35 scale zombie/apocalypse diorama.
A Lenz2 Vertical Axis Wind Turbine
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
Be nice to others! Respect the FreeCAD code of conduct!
- Quentin_Plsn
- Posts: 35
- Joined: Wed Aug 10, 2022 2:45 pm
- Contact:
Re: A Lenz2 Vertical Axis Wind Turbine
Very nice.... especially the DIY tutorial =)