Assembly4 model: cut using datum plane?

Discussion about the development of the Assembly workbench.
Post Reply
Anno Me Nuehm
Posts: 17
Joined: Tue Oct 20, 2020 8:50 am

Assembly4 model: cut using datum plane?

Post by Anno Me Nuehm »

Hi,

I've got an assembly4 model, a floor framing, from which I'd like to cut away a slanted portion (reflecting the sloped floor), and I was wondering if for this very purpose I could facilitate a datum plane, set at the required angle?

If so how would I then go about cutting away from the frame everything below said plane?

--Anno
smktec
Posts: 153
Joined: Thu Mar 05, 2020 5:37 pm

Re: Assembly4 model: cut using datum plane?

Post by smktec »

I may not be quite sure what you plan to.
But assembly model is normally used to simulate movements. So if your parts change like your desired cut you could do that in your designed part.
If this part has been put into your asm4 model by a link the linked part will automatically change as well.
Post Reply