FreeCAD Forum

Hello.

Recently I was able to use the LinearPattern function.

I got the desired effect quite smoothly but adjusting the displacement of the elements was too painful for me.
My problem was that I spent a lot of time determining the required intervals between successive occurrences.

At present it is not possible to set a value for the interval between successive occurrences because the program arranges successive occurrences on a completely different principle. The interval is calculated by the program.

My question:
Is it possible to add an option that would modify the arrangement of subsequent occurrences:

• as it is so far
• by specifying a fixed interval between successive occurrences

Greetings to all of you.

Thanks for the link.
That's the functionality I was looking for.
Except that I would measure only the distance between successive occurrences.


I am glad that such functionality will be available in the near future.