I do not know what else to say. I tried your new file, and everything worked right out of the box. I did not recompute or otherwise change anything.
You switched from Engrave to Vcarve, but I tried both and they worked. (One needs faces and the other needs edges.)
One thing I thought about that my standard setup sheet uses the default 1 mm extension around the model to create the stock box. You seem to have everything set to zero. I tried playing with this a bit on your original file, and the Part.MakeBox function appears to require non-zero dimensions. Even one micron will do. The exactly zero height in your setup may be the cause of problems. However, both of your files show stock boxes with non-zero height, so I do not know how this matters.
Gene
2D job creation fails.
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
Be nice to others! Respect the FreeCAD code of conduct!
Re: 2D job creation fails.
Thanks. Where have I set that ?You seem to have everything set to zero.
I think the AppImage is not picking up some of my defaults since it did not catch my recently used files the first time I ran it. This could be move the in where these are stored recently. That could at least explain the different results.
Yes, I tried one of each just to get some more input.You switched from Engrave to Vcarve
Not the total story yet but you may have found a sane explanation.