Release notes for FreeCAD 0.21
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
Be nice to others! Respect the FreeCAD code of conduct!
Release notes for FreeCAD 0.21
This is the forum thread for new 0.21 features.
Here is the Wiki page for the release notes: https://wiki.freecadweb.org/Release_notes_0.21
Here is the Wiki page for the release notes: https://wiki.freecadweb.org/Release_notes_0.21
Re: Release notes for FreeCAD 0.21
Removal of deprecated functions in TechDraw
https://github.com/FreeCAD/FreeCAD/pull ... 7113035295
[TechDraw] Remove deprecated replaceCosmeticVertex
[TechDraw] Remove deprecated replaceCosmeticEdge
[TechDraw] Remove deprecated replaceCenterLine
[TechDraw] Remove deprecated replaceGeomFormat
https://github.com/FreeCAD/FreeCAD/pull ... 7113035295
[TechDraw] Remove deprecated replaceCosmeticVertex
[TechDraw] Remove deprecated replaceCosmeticEdge
[TechDraw] Remove deprecated replaceCenterLine
[TechDraw] Remove deprecated replaceGeomFormat
Re: Release notes for FreeCAD 0.21
Thanks.bensay wrote: ↑Tue Aug 02, 2022 8:39 pm Removal of deprecated functions in TechDraw
https://github.com/FreeCAD/FreeCAD/pull ... 7113035295
[TechDraw] Remove deprecated replaceCosmeticVertex
[TechDraw] Remove deprecated replaceCosmeticEdge
[TechDraw] Remove deprecated replaceCenterLine
[TechDraw] Remove deprecated replaceGeomFormat
Please add them directly to
https://wiki.freecadweb.org/Release_not ... provements
(In case you have no Wiki permissions yet, please ask for them in the Wiki subforum. You develop a lot and you will most probably also have to update the TechDraw docs.)
-
- Posts: 4
- Joined: Sun Feb 26, 2023 4:36 pm
- Contact:
Re: Release notes for FreeCAD 0.21
extend command Part_PointsFromMesh to support any geometric type
#8730
#8730
Re: Release notes for FreeCAD 0.21
Thanks. Could you make a proposal for the text (1 or 2 sentences)? I am asking because looking at the PR I cannot figure out what the novelty is.Utkarshkumar wrote: ↑Sat Mar 04, 2023 4:14 pm extend command Part_PointsFromMesh to support any geometric type
#8730
Re: Release notes for FreeCAD 0.21
I have changed the subject of this topic from:
Release notes for FreeCAD 1.0
to:
Release notes for FreeCAD 0.21
The OP has been changed accordingly.
See:
viewtopic.php?t=77989
Release notes for FreeCAD 1.0
to:
Release notes for FreeCAD 0.21
The OP has been changed accordingly.
See:
viewtopic.php?t=77989
Re: Release notes for FreeCAD 0.21
The page still links to FreeCAD 1.0 Development Cycle.
While the content of section "Minimum supported library versions" does apply to 0.21, the rest of the page most certainly doesn't.
Re: Release notes for FreeCAD 0.21
I have removed the link.