M4x wrote: ↑Fri Jul 14, 2023 4:20 am Regarding modifying the current dialog: adrianinsaval is currently working on it

That's great. Looking forward to seeing the results!

probably discussion is ended long time ago. Perhaps it's not such a bad idea to open the discussion again. I recently had to explain the Hole tool to someone and we both agreed that it's a great tool, but a bit intimidating at first. Basically the tool is just a single form full of parameters, it t...

The profile should not be rectangular, it is for a gear..... As Workshop_Notes mentioned, this is for a roller cam drive. You can see one in action here: https://www.youtube.com/watch?v=YKYAOe1Bzho&t=28s Obviously these mechanisms are very much alike, but not exactly the same. Thank you for you...

with Part Wb the file is much smaller Thank you for your efforts! I hope you had fun with it. The first one has an artefact inside the groove on the left side. It's visible in the picture you posted, too. I'm not sure what's going on there. The second file is almost correct, I think. You are using ...

Syres wrote: ↑Thu Feb 23, 2023 4:36 pm Attached is the BSpline created from the folowing (older) Parametric Curve macro:

Thanks for your reply. I'm not sure how to use the macro to achieve the result from the video. Can you explain? Thanks in advance!

Hello all, here's a challenge. I was watching this video which shows the creation of a toolpath and the subsequent machining of a roller cam drive screw : https://www.youtube.com/watch?v=dhT1niomS7I Without the rollers it's called a double enveloping worm screw . You can look these terms up to see m...

better to configure with qt5ct some theme that is available for both gtk and qt Thanks for the tip, I will look into this further (but it may have to wait a few days). for convenience you could create a symlink to this (I do this) sudo ln -s /opt/freecad/bin/FreeCAD /usr/bin/freecad-opt sudo ln -s ...

Hello and merry Christmas if you're someone who celebrates that. I usually build my FreeCAD from master, according to the instructions on https://wiki.freecadweb.org/Compile_on_Linux. Last week I caught on to the fact that this practice left me with an outdated version of the OCCT libraries, and som...

What kind of documentation are you looking for? So far I have used the recipe for building as laid out in https://wiki.freecadweb.org/Compile_on_Linux but this doesn't mention compiling OCCT with the patches. So I guess I was wondering if there was a more recent version of this document. I suppose ...

GeneFC wrote: ↑Thu Dec 22, 2022 9:43 pm There is no requirement for you to [...]

Again I'm unsure what you mean. Have I insulted you or something?